Inserting And Ejecting Disc; Inserting Disc - Hitachi DZMV230A Instruction Manual

Inserting and Ejecting Disc

Inserting Disc

With this DVD video camera/recorder the recorded video and audio are stored on DVD-RAM* or DVD-R disc.
* When using an uninitialized DVD-RAM disc, it must be formatted (see p. 87).
1
Make sure that the
DVD video camera/
recorder is turned off.
Set the power switch to
"POWER OFF".
2
Press down the DISC
EJECT button.
The cover of disc
insertion block (hand
strap) will slightly
open.
3
Gently open the
cover by hand
until it stops.
4
Insert the disc, in cartridge or caddy, into the
disc guide.
Set a both-side recordable disc into the disc guide
so that the label of side on which you want to
record faces the hand strap.
Power switch
DISC EJECT button
How to set both-side recordable disc
•The actual recording surface of side [A] is op-
posite to that on which "SIDE A" is marked. If
you view the image recorded on side [A] on
another device, set the disc in it with indica-
tion "SIDE A" facing up.
Laser
Actual
recording
surface
•The cartridge has a fixed orientation when it
is inserted into the DVD video camera/re-
corder: Insert it correctly referring to the illus-
tration shown below.
To record on side [B], remove the disc from car-
tridge and turn the disc over.
How to set one-side recordable disc
•Set the disc with the label side up in the caddy,
and then insert the caddy correctly referring
to the illustration shown below.
The caddy has a mark: Insert it with this
mark forward.
A
Side A
indica-
tion of
disc
37
English