Setup For Windows - 3Com ISDN Modem User Manual

3-20 C
HAPTER
10 Click Continue.
11 Click OK to exit the Network Settings dialog box.
The Network Settings Change alert box appears.
12 Click Restart Now.
Once your computer has rebooted, you are ready to use the
3C882 ISDN modem.
Refer to Chapter 5, "Advanced Configuration," to review the
default settings and ensure that they reflect your preferences.
If you prefer not to change the default settings, then go on
to Chapter 7, "Placing and Receiving Calls".
Setup for Windows NT 4.0
This section describes how to set up the 3C882 ISDN modem
using Windows NT 4.0. Note that these instructions assume
that the 3C882 ISDN modem software has already been
installed.
These instructions also apply for Windows 95 manual setup.
1 Insert the 3ComImpact IQ Windows Installation Diagnostic
Utilities diskette into an available floppy drive.
2 From the Control Panel dialog box, double-click the
Modems icon.
The Modems Properties dialog box appears.
3 Click Add.
The Install New Modem dialog box appears, as shown in
Figure 3-18.
3: C
ONFIGURATION FOR AN
IBM-C PC R
OMPATIBLE
W
UNNING INDOWS