Connections; Power Input; Voltage Select - Focusrite Green Range Manual

Connections

All of the unit's connections are on the rear panel.
All XLR connectors wired as follows: pin 1-X-Screen pin 2-L-Live-Signal 0˚ pin 3-R-Return-signal 180º

Power Input

There is an IEC mains lead supplied in the package which should have the correct
moulded plug for your country. The wiring colour code used in all Focusrite products is:
For units shipped to the USA, Canada, Taiwan and Japan
Live – Brown Neutral – Blue Earth – Green and Yellow
The chassis is connected directly to the mains safety earth. We do not provide an
earth lifting switch, since such a switch can allow for a dangerous wiring
arrangement.
Warning: For safety reasons, it is absolutely IMPERATIVE that the mains safety earth is
connected.

Voltage Select

The Channel Strip will operate on a range of voltages, and has a two-position switch
on the rear panel that should be set to the correct voltage:
115V
230V
To comply with the safety codes in some countries, modules may be supplied without
a voltage selector. In this case, the module is preset to the local supply voltage, which
is clearly marked on the rear of the module. Check that the voltage is set correctly.
The module will work correctly from either 50Hz or 60Hz power supplies, and draw
approximately 35VA from the mains supply at highest load.
Voltage
select
85/120v
200/240v
Key &
Link Instrument Input
Comp link = Tip
N/C = Ring Retn 180 R = Ring
Chassis = Shield Chassis = Shield
Live – Black Neutral – White Earth – Green
For units shipped to any other country
Set to this position if the module is to be used with
voltages in the range 85V to 120V
Set to this position if the module is to be used with
voltages in the range 200V to 250V
Link Key
In
Out
Live O L = Tip
Ext Key
s e t t i n g u p
Instrument
Input
Hi–Z
+18dB
Line
Output Inst Line Input Mic Input
7