Using The Low Mid Eq And High Mid Eq - Focusrite Green Range Manual

e q u a l i s e r
Controls
• Freq sets the centre point of the affected frequencies.
• dB sets the amount of attenuation or gain applied to the affected frequencies.
• The Fine button sets the range of frequencies affected. Note that the Fine setting
for the Low Mid Eq is narrower than the Fine setting for the High Mid Eq, for a
tight bass sound.
Off position: Set the gain control in the middle position, so that it is neither boosting
nor cutting frequencies.
Using the Low Mid and High Mid Eq
Use them to colour the sound and create a presence. For example, you can take the
sound of a vocal and improve its clarity in the mix. To isolate the frequency you want
to boost or cut:
1. Add some gain to the signal, so that you can hear the effect easily.
2. Ensure that Fine is not switched in, so that it is easier to hear the area you are
affecting.
3. Modify the frequency until you find the area you want to work on.
4. Modify the gain to control the amount of the selected frequency that is added to
or subtracted from the signal.
5. If you want to affect a narrower band of frequencies (for example, to give a tight
bass sound), use the Fine switch.
16
– +
Fine
Freq
dB
Low Mid
Eq
Hz
– +
Fine
Freq
dB
High Mid
Eq
Hz