Starting The Pump; Stopping The Pump; Resetting The Pump To Factory Defaults - Pentair Pool Products INTELLIFLO VS-3050 Installation And User Manual

Starting the pump

To start the pump
1. Ensure that the pump is powered on and the green power LED is on.
2. Press the Start button (LED on) to start the pump.
Note: When the pump is using a modified speed and is powered down, the next time the pump is
powered up, the pump will use that same speed.

Stopping the pump

To stop the pump
• Press the Stop button to stop the pump.
Note: The pump can automatically restart if the communication cable is connected.

Resetting the pump to factory defaults

The IntelliFlo VS pump can be reset to the factory default settings. All previously adjusted pump speeds
®
that were saved will be erased.
To reset the pump to the factory default settings:
1. Ensure that the pump is powered on and the green power LED is on.
2. Press the Stop button to stop the pump.
3. Press and hold all of the four Speed buttons simultaneously for three seconds. Power off the
drive and reenergize. The default settings will be in effect.
Control Panel Speed Buttons
11