EverFocus Eq250 Operation Instructions Manual page 6

1. C/CS mount Focus Switch Ring
Use this ring to adjust the appropriate focal length according to the type of lens. Rotate the
ring clockwise for the CS-mount lens, rotate it counterclockwise for the C-mount lens. The
factory setting is CS-mount.
2. Lens Mount
To mount an appropriate C-mount or CS-mount lens.
3. Locking Screw
Use the locking screw to fix the focal length for
4. DC Lens Connector (4 pin socket)
To connect to the lens plug of the auto iris lens.
5. Camera Setting DIP Switches
There are 6 DIP switches located on the sideboard, which are for camera setting. The
switches in order from top is Flickerless, Back Light Compensation, Electronic Shutter,
Automatic Gain Control, Line-Lock and Auto Iris Lens type. Please see camera DIP
switch setting section.
6. IRIS Level Control
Brightness Level can be adjusted from the IRIS level VR while using the direct drive lens.
Turn counterclockwise to L to get darker picture.
Turn clockwise to H to get brighter picture.
7. V-Phase Adjustment Screw
The vertical phase may require adjustment to synchronize the vertical phase of the camera
with other camera in the system when it is being used in the line-lock sync mode. Make the
adjustment when the vertical phase of the camera does not match with other cameras.
preventing losing
5
focus.