Trouble Messages - Hitachi DZMV200E Instruction Manual

Trouble Messages

A message may appear while you are operating the DVD video camera/recorder. If a message ap-
pears, refer to the following table and take appropriate corrective action.
Message
(1) Error has occurred.
Please restart.
(2) Error has occurred.
Please reinsert a disc.
(3) Error has occurred.
Error code No. xxxx.
Please read
manual
(4) ERROR xxxx
Control Information Er-
ror.
Disc error.
No more scenes. Play
List was deleted.
Write protected.
Check disc cartridge.
Battery is almost
empty. Replace it.
Cannot combine. Se-
lect multiple scenes.
Cannot combine.
Deselect PHOTO
scenes.
Scenes over limit. Can-
not divide scenes.
Scenes over limit. Can-
not add scenes.
96
Error has occurred. Try to restart the DVD video cam-
era/recorder using the following methods:
(1) Turn power off, remove the battery pack or AC
adapter and reattach it, and then turn power on again.
(2) Turn power off, and reinsert the disc. Then turn power
on again.
(3) Take note of the number (xxxx), and then consult
the
your dealer.
Condensation might have occurred: Use the DVD
video camera/recorder only after it has dried.
(4) Try to repair using methods (1) and (2) above. If the
message still appears, take note of the number (xxxx)
and consult your dealer.
Mismatch may occur between the recorded image
and scene information.
Update the control information.
Disc may be dirty.
Remove the disc and wipe off fingerprints, dust, etc.
before reusing it, or use another disc.
Disc may be dirty.
Remove the disc and wipe off fingerprints, dust, etc.
before reusing it, or use another disc.
Mismatch in recording information may be caused by
editing done on some device other than this DVD video
camera/recorder.
Initialize the disc or use another disc.
All scenes are deleted from the play list.
Release write-protect of the cartridge. If the message
still appears, the disc may be software protected from
a device other than this DVD video camera/recorder.
To release this case, use a device that has executed
software-protect.
Replace with a charged battery, or use AC adapter
to power the DVD video camera/recorder.
Select a range of at least 2 scenes to be combined,
and then combine them.
Select only movies and combine them.
The number of entered scenes has reached the limit
that can be entered.
Delete several scenes.
The number of scenes entered in play list has reached
the limit that can be entered.
Delete several scenes.
Cause & Troubleshooting
Reference
page
30, 34,
37
20
87
23
23
86
77
25
31, 34
82
82
76, 77
76, 77