PEERLESS SmartMount SF670 Installation And Assembly Manual page 7

For Flat Back Screen
Begin with the shortest length screw, hand thread through multi-washer and adapter bracket (BB) into screen as
2-1
shown below. Screw must make at least three full turns into the mounting hole and fi t snug into place. Do not over
tighten. If screw cannot make three full turns into the screen, select a longer length screw from the baffl ed fastener
pack. Repeat for remaining mounting holes, level brackets and tighten screws.
NOTE: Spacers may not be used, depending upon the type of screen.
If you have any questions, please call Peerless customer care at 1-800-865-2112.
For Bump-out or Recessed Back Screen
Begin with longer length screw, hand thread through multi-washer, adapter bracket (BB) and spacer in that order
2-2
into screen as shown below. Screw must make at least three full turns into the mounting hole and fi t snug into
place. Do not over tighten. If screw cannot make three full turns into the screen, select a longer length screw from
the baffl ed fastener pack. Repeat for remaining mounting holes, level brackets and tighten screws.
If you have any questions, please call Peerless customer care at 1-800-865-2112.
SCREEN
ADAPTER BRACKET (BB)
SCREEN
SPACER
7 of 34
fi g 2.1
MULTI-WASHER
SCREW
fi g 2.2
MULTI-WASHER
SCREW
ADAPTER BRACKET (BB)
ISSUED: 11-09-07 SHEET #: 202-9253-4 08-31-10