Replacing The Speaker Module - Packard Bell EasyNote LJ65 Service Manual

Replacing the Speaker Module

1. Place the left Speaker Module in the chassis as
shown, ensuring that the locating pins are seated
correctly.
3. Continue running the cable along the Upper Cover
using all available cable clips.
5. Replace the four securing screws.
NOTE: Ensure that the Speaker cable runs as shown in the image below to avoid trapping when the Upper
Cover is replaced.
120
2. Lift the mylar sheet away from the Upper Cover and
run the Speaker cable along the Upper Cover using
all available cable clips.
4. Place the right Speaker Module in the chassis as
shown, ensuring that the locating pins are seated
correctly.
Chapter 3