Advertisement
2
3
4
5
6
7
TIP: In order to keep the slide legs from sinking into the ground, place a flat rock or a brick under the legs. You should dig
out a place for the brick so the slide remains even.
10
Insert the rail/ladder legs through the holes in the
top of the slide. Align the ladder holes with the
slide holes.
Insert the screws through the holes in the back of
the slide and secure them to the hand rails with the
screws and locking nuts provided.
Locate the slide front leg and insert it into the front
outside hand rail tube, on the underside of the
slide. Place a screw in that hole and secure it with
the lock nut.
NOTE: For stability, this leg should be placed on
the outside of the slide, opposite the swing set
frame.
Insert the screw into the remaining hole on the
slide and secure the hand rail to the slide with the
lock nut.
Slide the two ladder steps onto the legs of the slide.
Align the holes and secure the steps with the
screws and locking nuts. The screw head should
be facing the outside.
NOTE: Once assembled and the slide is standing
upright, the steps should be flat and parallel with
the ground. If they are at an angle, they will need
to be removed, turned around, and reassembled.
To attach the slide to the frame, locate the two link
bars, remove the hardware, and re-attach to the side
support bar with the holes.
Part Ref. #: PSHW24
Part Ref. #: PSHW24
Part Ref. #: PSHW24
Part Ref. #: PSHW5
Part Ref. # PSHW17
2006 Pacific Cycle, Inc.
©
Advertisement
