Craftsman 536.887993 Operator's Manual page 27

_.'_o_ V:_ _ I my:_m_ll_,_l i _vA I_ _i i
11. Remove the three fasteners that
hold the friction wheel to the hub
(see Figure 34).
12. Remove the friction wheel from the
hub. Slip the friction wheel off the
hex shaft.
13. Assemble the new friction wheel
onto hub with the fasteners re*
moved earlier.
14. Install the hex shaft and bearings
with the four bolts removed earlier
(see Figure 35).
Make sure the washers are prop*
erly installed in the original posi*
tion. Also, make sure the two
washers are properly aligned
with the actuator arms.
15. Make sure the hex shaft turns free-
]y.
16. Install the left wheel, axle, and
drive sprocket with the fasteners
removed earlier, install the chain
onto the drive sprocket (see
Figure 32).
17. Check the adjustment of the friction
wheel. See "How To Adjust The
Friction Wheel" in this section.
18. Make sure the friction wheel and the
disc drive plate are free from grease
or oil.
19. Install the bottom panel (see
Figure 31).
20. Tighten the bolts on each side of
the bottom panel.
21. Install the right wheel to the axle
with the fasteners removed earlier.
22, Connect the spark plug wire,
Friction
Fasteners Hub Wheel
Hex Shaft
Fasteners
Figure 34
F-031098L
Actuator Arms
Bearings
\
Washer
27
Beanngs
/
Washer
Washer
Figure 35