Using The Trigger - Craftsman 172.17174 Owner's Manual

Your
1 0.0-amp reciprocatingsaw has many built-in conveniencefeatures for fast. efficient
cutting,These features include a variable speed tdgger switchthat allowsyou to change
the speeds for cutting a variety of materials. An adjustable/pivoting shoe for maximum
controlin a vadety of cuts and an easy-to-grip rubber boot.The tool-lessb_ade clamp has
easy lever actionfor extra bst blade changes.
Fig. 1 _amp
A.dj=._aUe J \ _----_ /kJ Handle
FlvoUng Shoe Rubber B_t _-,._'_1-'._ Grip
Input
Blade Stroke
BladeType
Rating
No-load Speeds
10.0 Amps
11/8 in.
'1/2in. Universal Shank
120 volts, 60 Hz AC
0 to 2600 SPM
Beforeattempting to use any tool, be sure to familiarize yourselfwith all
the operating features and safety instructions.
Z_WARNING:
IF ANY PARTS ARE MISSING, DO NOT OPERATE
THIS SAW UNTILTHE MISSING PARTS ARE REPLACED. FAILURE TO
DO SO COULD RESULT IN POSSIBLE SERIOUS PERSONAL INJURY.
Z_ CAUTION:
DO NOT let familiarity with your saw make you
careless. Remember that a careless fraction of a second is sufficient to
cause severe injury.
Z_ CAUTION:
ALWAYS wear eye protection while operating this
power tool.
USING THE TRIGGER SWITCH TO CONTROL VARIABLE SPEED
This saw is equipped with a variable speed trigger switch. The saw can be
turned ON or OFF by squeezing or releasing the trigger switch.
The speed of the blade can be adjusted by the pressure you apply to the
trigger switch.
8