Mains Power Connection - Pro-Ject Audio Systems Amp Box Mono Instructions For Use

Dear music lover,

thank you for purchasing a PRO-JECT AUDIO amplifier.

In order to achieve maximum performance and reliability you should study these instructions for use carefully.

Warning of a hazard for the user, the unit or possible misuse.

Important notice.

Connectors

by pass

Input

output

Make all connections whilst the amplifier is disconnected from the power supply.

Connection to the preamplifier

The socket marked Input is for connecting the cables from your pre-amp or AV processor. The preamplifier

signal can be relayed to further units via the by pass output socket.

Connection to the speaker

The output terminal accept loudspeaker cables terminated with 4mm ∅ Banana plugs, spades connectors or

naked wire.

Only connect one loudspeaker with an impedance not less than 4 Ohm.

Red terminal carry the positive signal (+), black connections the negative signal (–). Make sure the

polarity of the connection is correct at each end of the cables.

Mains power connection

The unit is supplied with a power supply suitable for your country's mains supply. Check the label before

connecting to ensure compliance with the mains rating in your house. Connect the low voltage plug from the

power supply to the Power 20V

Never use any other DC power supply other than the one supplied with the unit.

Remote power on

The amplifier can be switched on & off via a special connection from the Pro-Ject Pre Box via the 2,5mm

socket marked Trigger In.

A 45cm long power-on cable (polarity

accessories. The remote power-on signal can be relayed to further units via the Trigger Out socket.

Stand-By

The Power button on the front panel of the unit alternately turns the power on or returns it to standby mode.

The blue LED on the front panel shows that the unit is powered on.

Out

socket of the amplifier before connecting the power supply to the mains.

) is supplied for this purpose. Longer cables are available as