Download Print this page

Pro-Ject Audio Systems Amp Box Mono Instructions For Use page 3

Advertisement

Technical specifications Pro-Ject Amp Box Mono
Power output:
Frequency response:
Noise floor:
THD:
Gain:
Pre in:
Input sensitivity:
Input impedance:
Pre out:
Speaker connector:
Trigger:
Trigger in and out:
Outboard power supply:
Power consumption:
Dimensions W x H x D (D with sockets): 103 x 36 x 103 (122)mm
Weight:
Service
Should you encounter a problem which you are not able to alleviate or identify, please contact your dealer for
further advice. Only when the problem cannot be resolved there should the unit be sent to the responsible
distributor in your country.
Warranty
The manufacturer accepts no responsibility for damage caused by not adhering to these instructions
for use. Modification or change to any part of the product by unauthorized persons release the
manufacturer from any liability over and above the lawful rights of the customer.
PRO-JECT is a Registered Trademark of H. Lichtenegger.
This guide was produced by: Audio Trade GmbH
Copyright © 2007. All rights reserved.
28W/40W at 8ohms/4ohms
5Hz - 20kHz (+ 0dB, - 0,5dB)
> -100dB (A weighted)
< 0,05% at 10W
22dB
1 RCA/Phono socket
1V
47kohms
1 RCA/Phono socket
4mm ∅ banana plugs, spades connectors or naked wire
12V DC switching voltage
2-pole co-axial ∅ 2,5mm jack
20V/3A DC (peak 7A DC), suitable for your country's mains supply
20V/3A DC
670g without power supply
© Audio Trade GmbH · Pro-Ject Amp Box Mono · Revision 15.10.10/15.12.10
The information was correct at the time of going to
press. The manufacturer reserves the right to make
changes to the technical specification without prior
notice as deemed necessary to uphold the ongoing
process of technical development.
3

Advertisement

loading