Installation - Alpine CDE-9846RM Owner's Manual

Installation

Accessory List
• Head unit ........................................................................ 1
• Power cable .................................................................... 1
• Mounting sleeve ............................................................. 1
• Carrying case ................................................................. 1
• Rubber Cap .................................................................... 1
• Hex Bolt .......................................................................... 1
• Screw (M5 × 8) ................................................................ 4
• Owner's Manual ....................................................... 1 set
Note:
The main unit must be mounted within 35 degrees of the horizontal
plane, back to front.
Less than 35°
1
Bracket
Dashboard
Mounting sleeve
(Included)
Slide mounting sleeve from main unit (see
"Removal" on this page). Slide the mounting sleeve
into the dashboard and fix it with the metal
shackles.
2
Metal Mounting Strap
∗
Hex Nut (M5)
When your vehicle has the Bracket, mount the long
hex bolt onto the rear panel of the CDE-9848RB/
CDE-9846R/CDE-9846RM and put the Rubber Cap
on the hex bolt. If your vehicle does not have the
Mounting Support, reinforce the head unit with the
metal mounting strap (not supplied). Connect all
the leads of the CDE-9848RB/CDE-9846R/CDE-
9846RM according to details described in the
CONNECTION section.
• For the screw *, provide a proper screw to the chassis installing
location.
Rubber Cap
(Included)
Hex Bolt
(Included)
this unit
Screw
Bolt Stud
this unit
3
Slide the CDE-9848RB/CDE-9846R/CDE-9846RM
into the dashboard. When the unit is in place, make
sure the locking pins are fully seated in the down
position. This can be done by pressing firmly in on
the unit while pushing the locking pin down with a
small screwdriver. This ensures that the unit is
properly locked and will not accidentally come out
from the dashboard. Install the Detachable Front
Panel.
Removal
1 Remove the detachable front panel.
2 Use a small screwdriver (or similar tool) to push the
locking pins to the "up" position (see above drawing).
As each pin is unlocked, gently pull out on the unit to
make sure it does not re-lock before unlocking the
second pin.
3 Pull the unit out, keeping it unlocked as you do so.
<JAPANESE CAR>
this unit
Lock pin
Front frame
Screws (M5 × 8)
(Included)
Mounting Bracket
21
-EN