Connections - Panasonic TH-42PD12U Operating Instructions Manual

Connections

When connecting the speakers, be sure to use only the optional accessory speakers.
Refer to the speaker's Installation Manual for details on speaker installation.
Speakers (Optional accessories)
Note:
Make sure that the AC cord
is locked on both the left and
right sides.
– Cable fi xing band
Secure any excess cables with band as required.
Note:
One fi xing band is supplied with this unit. In case of securing cables at two positions, please purchase it separately.
Pass the attached cable
fi xing band through the clip
as shown in the fi gure.
1
INPUT1: Video input terminal
INPUT2: S Video input terminal
INPUT3: Component/RGB Video input terminals
Connect a video device such as VCR or DVD player. (see page 12)
Speaker terminal (R, L)
– AC cord fi xing
1
Plug the AC cord into
1
the display unit.
Plug the AC cord until
it clicks.
2
Fix the AC cord with
2
the clamper which is
attached to the unit.
To secure cables connected to Terminals, wrap the cable fi xing band around them
then pass the pointed end through the locking block, as shown in the fi gure.
While ensuring there is suffi cient slack in cables to minimize stress (especially
in the power cord), fi rmly bind all cables with the supplied fi xing band.
2
INPUT4: PC input terminal
From EXTERNAL monitor
terminal on computer
(see page 10)
AC cord
connection
(see page 13)
Unplug the AC cord
Close
Push until
the hook
clicks.
Open
2. Pull off.
Note:
When disconnecting the AC cord, be
1. Keep the
absolutely sure to disconnect the AC
knob
cord plug at the socket outlet fi rst.
pressed.
To tighten:
Pull
From SERIAL From audio output terminal
terminal on on external equipment
computer connected to INPUT1 to 4
(see page 11) (see page 10, 12)
1
2
1
2
Unplug the AC
cord pressing
the two knobs.
To loosen:
Push the catch
Pull
9