Connecting The Machine To The Power Source; Connecting The Machine; Foot Control - Euro-Pro INTELLI SEW 9136C Instruction Manual

CONNECTING THE MACHINE TO THE POWER SOURCE

01
6

Connecting the machine

Before connecting the power supply, make
sure that the voltage and frequency shown
on the machine is conforming with your
electrical power.
Place the machine on a stable table.
1. Connect the power line plug to the
electric outlet.
2. Turn on the power switch.
3. The sewing lamp will light up when the
switch is turned on.
Caution:
Always make sure that the machine is
unplugged from power source and the main
switch is on "O" when the machine is not in
use and before inserting or removing parts.
Polarized plug information
This appliance has a polarized plug (one blade
wider than the other), to reduce the risk of
electrical shock; this plug will fit in a polarized
outlet only one way. If the plug does not fit
fully in the outlet, reverse the plug. If it still
does not fit, contact a qualified electrician. Do
not modify the plug in any way.

Foot control

With the sewing machine turned off, insert
the foot control plug into its connector on
the sewing machine. Turn on the sewing
machine, and then slowly depress the foot
control to start sewing. Release the foot
control to stop the sewing machine.
Attention:
Consult a qualified electrician if in doubt as
how to connect the machine to the power
source. Unplug the power cord when the
machine is not in use.
The appliance must be used with the foot
controller C-9000 manufactured by CHIEN
HUNG TAIWAN., LTD.