GE PGSS5PJZASS Owner's Manual And Installation Instructions page 17

Installation Instructions
r2]LOCATING THE ANTI-TIP
FLOOR BRACKET {cont.)
Figure 2- Acceptable Screw Placement
Locations
PreferredInstallation- PreferredInstallation-
Wood Concrete
MinimumAcceptable#1 -
Wall PlateStud
MinimumAcceptable#2 - Wood
Floor
MinimumAcceptable#3 -
ConcreteFloor
[_] ANTI-TIP BRACKET INSTALLATION
r_ WOOD Wall and Floor Construction:
• Drill the appropriate number of 1/8" pilot
holes in the center of each floor bracket hole
being used (a nail or awl mag be used if o drill
is not available) AND remove the Iocator
template from the floor.
Mount the anti-tip floor bracket bg fastening
the 2, or preferoblg 4, #10-16 hex-heod
screws tightlg into place as illustrated in
Figure 5.
Figure3 - Attachment to
Wall and Floor
RearRHCornerof
the Refrigerator
2 ScrewsMust Floor
EnterWood or Bracket
Metal Stud
Wall
Wall
Plate
Stud
Floor
r_ CONCRETE Wall and Floor Construction:
• Anchors required (not provided):
a each 1/a" x 1 1/2" log bolts
4 each 1/2" O.D. sleeve anchors
Drill the recommended size holes for the
anchors into the concrete at the center of
the holes marked in Step 2.
Install the sleeve anchors into the drilled
holes. Place the anti-tip floor bracket us
indicated in Step 2. Remove the Iocator
template from the floor.
• Install the lug bolts through the anti-tip floor
bracket and tighten appropriotelg.
r_ WOOD Wall and TILE Floor Construction:
For this special case, locate the 2 wall holes
identified in Fig. 1. Drill an angled 1/8" pilot
hole (approx. as shown in Fig. 3)in the center
of each hole.
Haunt the anti-tip floor bracket using the
Hinimum Acceptable Installation #1, as
illustrated in Fig. 2.
@
%
[]
@
POSITIONING THE REFRIGERATOR
TO ENGAGE THE ANTI-TIP FLOOR
AND BASE BRACKETS
Before pushing the refrigerator into the
opening, plug the power cord into the
receptacle and connect waterline (if equipped).
Check for leaks.
Locate the refrigerator's RH side and move
buck upproximatelg in line with the RH side of
the cabinet opening, W. This should position the
anti-tip floor bracket to engage the anti-tip
base bracket on the refrigerator.
Gentlg roll the refrigerator buck into the
cabinet opening until it comes to u complete
stop. Check to see if the refrigerator front lines
up with the cabinet front face. If not, corefullg
rock the refrigerator forward and backward
until engagement occurs and gou notice that
the refrigerator is fullg pushed up against the
rear wall.
OPTIONAL: Adjust the rear (and front) wheel
height settings to fullg engage the rear anti-tip
brackets, while also aligning the refrigerator
front with the cabinet front face.
17
NOTE:
If you pull the refrigerator out and away from the
wall for any reason, make sure the anti-tip floor
bracket is engaged when the refrigerator is pushed
back against the rear wall.