Craftsman BRUSHWACKER 358.795822 Operator's Manual page 7

2. Place t he upper shoulder strap
clamp over t he shaft.
3. Position the lower shoulder strap
clamp under the shaft and align t he
upper and lower clamp screw holes.
ASSEMBLY INFORMATION -
TRIMMER HEAD
TRIMMER
HEAD
Upper Shoulder
! J Strap Clamp
Lower Shoulder ! l
Strap Clamp
Screws
4. Insert two screws into the screw
holes.
5. Secure shoulder strap clamp by
tightening screws with a hex
wrench.
HARNESS
ADJUSTMENT
FOR BALANCE
(15 cm) 4 - 12 inches
below --._-_ (10 - 30cm)
waist 30 inches above
(76 cm_ und
30inches
(76 cm)
INSTALLATION OF THE TRIMMER
HEAD
NOTE: Before installing the trimmer
head, make sure the dust cup and re-
taining washer are positioned on the
shaft of the gearbox. The retaining
washer must be positioned with the
raised section toward the gearbox.
1. Align hole in the dust cup with the
hole in the side of the gearbox by
rotating the dust cup.
2. Insert a small screwdriver into
aligned holes. This will keep the
shaft from turning while tightening
trimmer head.
Screwdriver _
NOTE: Make sure all parts are prop-
erly installed as shown in the illustra-
tion before installing the trimmer head.
3. While holding the screwdriver in
position, thread trimmer head onto
the shaft by turning counterclock-
wise. Tighten until secure.
,L_ Gearbox
I
_j- Dust Cup
i_ ,G._ Retaining
Washer
Cutting Head I
4. Remove the screwdriver.
g