25cc/1.5 cu.in. 2-cycle 17 inch cutting path / 0.080 inch line gasoline weedwacker (30 pages)
Summary of Contents for Craftsman 358.795700
Page 1
Operator's Manual I CRRFTSMRN°I 19cc/1.2 cu. in. 2-Cycle GASOLINE HEDGE TRIMMER Model No. 358.795700 - 18" Blade WARNING: Read and follow all Safety Rules and Operating Instructions before first use of this product. For answers to your questions about this product: Call 7 am-7 pm, Mon-Sat;...
Page 2
Parts and Ordering Back Cover FULL ONE YEAR WARRANTY ON CRAFTSMAN ® GAS POWERED HEDGE TRIMMER For one (1) year from the date of purchase, when this Craftsman Gas Powered Hedge Trimmer is maintained, lubricated, and tuned up according to the operat-...
Page 3
Blades can t hrow objects violently. • You c an be blinded orinjured. • Wear safety glasses. Glasses B oots HAZARD ZONE _ ....& WARNING: Hazard zone for t hrown objects • Blades can t hrow o bjects violently. •...
S ears Service Center. tee the avoidance ofthese p roblems. • Use only recommended Craftsman cutting blades and replacement Users who operate power tools o na continual and regular basis m ust moni- parts; use ofany other parts m ay...
Use fresh quality 2-cycle air-cooled engine oil. fuel next season. We recommend Craftsman brand oil. Never use engine or carburetor cleaner Mix gasoline and oil at a ratio of 40:1 products in the fuel tank or permanent (A 40:1 ratio is obtained by mixing 3.2...
Page 6
OPERATING POSITION ..Switch Protection € t_LX, k._/ 3. Slowly press the primer bulb 6 times. 4. Move the choke lever to the FULL STOPPING YOUR ENGINE CHOKE position. • To stop the engine, move the ON/OFF Choke switch to the OFF position. BEFORE STARTING THE ENGINE...
Page 7
tion, move the choke lever to the 6. Release the throttle lock by squeez- HALF CHOKE position and pull the ing and releasing the throttle trigger. rope until engine runs, but no more NOTE: If engine has not started, pull starter rope 5 more pulls.
Adirty airfilter d ecreases engine per- 2.Remove spark p lug f rom cylinder and discard. formance and increases fuel consump- tion and harmful emissions. Always 3.Replace with Champion RCJ-8Y clean a fter e very 5 hours o foperation. spark p lug and tighten with a3/4 in. 1.Clean t he cover and the area socket wrench (10-12 ft.-Ibs).
Page 9
Initial Settings High Speed Mixture - H 1. Turn both mixture screws (L and H) CAUTION: Do not operate engine at full counterclockwise until they stop. throttle for prolonged periods while mak- 2. Turn the idle speed screw clockwise ing high speed adjustments as damage until it stops.
Run engine Position unit so that any sharp object at least 5 minutes after adding stabilizer. cannot accidentally cause injury. Craftsman 40:1,2-cycle engine oil (air • Store unit and fuel well out of the cooled) is already blended with fuel reach of children.
TROUBLESHOOTING TABLE WARNING: Always stop unit and disconnect spark plug before perform- ing all of the recommended remedies below except remedies that require operation of the unit. REMEDY CAUSE TROUBLE Engine will not 1. ON/OFF switch in the OFF 1. Move ON/OFF switch to the ON start.
1-800-473-7247. WARRANTY PERIOD: any emissions related part on your en- gine (as listed under Emissions Control Any warranted part which is not sched- Warranty Parts List) is defective or a de- uled for replacement as required mainte- fect in the materials or workmanship nance, or which is scheduled only for the engine causes the failure of such an regular inspection to the effect of "repair...
Need help?
Do you have a question about the 358.795700 and is the answer not in the manual?
Questions and answers