To Adjust Depth With Depth-Adjustment Wrench - Craftsman 320.27666 Operator's Manual

The speed charts above indicate the relationship between the speed
setting and the cutting application. Exact settings are determined through
operator experience and preference, and also by recommendations made by
manufacturers of cutter bits.
TO ADJUST DEPTH WITH DEPTH=ADJUSTMENT WRENCH (Figs. 21, 21a )
NOTE: The Depth-Adjustment Wrench
supplied is used to adjust the depth when the
router is fixed to the router table (Model No.
320.28160), sold separately. (Fig.21)
A_, WARNING: Always read and follow all
directions for mounting the router to a router
table and for use of the router table.
_, WARNING: Always turn the router motor
off and unplug the router from the power
source before making any adjustments or
installing accessories. Failure to turn the
router motor off and unplug the router could
result in accidental starting, which can cause
serious personal injury.
_, WARNING: Only use router tables with
proper guarding for the cutting bit and with
"on-board" switch-controlled receptacles.
Failure to use router tables with appropriate
safety features could result in serious
personal injury.
Fig. 21
Fig. 21a
When using the plunge base to attach the
router to the router table, the bit depth can be
adjusted by turning the depth rod clockwise
or counterclockwise with the wrench supplied (Fig. 21a).
1. Turn off the router.
2.
3.
Lock the Plunge Depth Locking Lever.
Insert the wrench into the adjusting hole on the tabletop. Turn the depth
rod on the router clockwise with the wrench to move the collet/nut up or
counterclockwise to move the collet/nut down
4. When the desired depth of cut is set, tighten the plunge-lock lever. The
precise depth of cut can be measured with a ruler.
27666 ManuaLRevised_11-0114 Page 29