Troubleshooting - Craftsman 320.27666 Operator's Manual

PROBLEM CAUSE SOLUTION
Plug is not plugged into Plug the cord into the power
the power source, source.
Switch is in "OFF"
The router position. Pull the switch to "ON" position.
does not work
The carbon brushes Remove the brush caps, and
have worn out replace the old brushes with new
completely, ones.
The surface of The bit is dull. Change to a sharp bit.
the workpiece
is not smooth Routing at an
after cutting inappropriate bit speed Select an appropriate bit speed.
Bit can not be
installed
Bit size is inappropriate
for the collet/nut
Use only 1/4-in. diameter bits with
the 1/4-in. collet; use only 1/2-in.
diameter bits with the 1/2-in.
collet.
27666 ManuaLRevised_11-0114 Page 32