Dust Collection With Vac Adapter; Heavy-Duty Edge Guide - Craftsman 320.27666 Operator's Manual

_1, WARNING: Always turn the motor off
and unplug the router from the power source
before making any adjustments or installing
accessories. Failure to turn the motor off and
unplug router could result in accidental starting
which can cause serious personal injury.
DUST COLLECTION WITH VAC ADAPTER (Fig. 18)
The vac adapter is sized to accept a 1-1/4 inch.
vac hose adapter, sold separately.
To attach the port onto the plunge base, position
and secure it to the back of the base with the
two screws (included), as shown in Fig. 18.
The vac adapter can also be installed with the
hose outlet facing the front of the plunge base
by removing the chip shield and attaching the
port at the front of the base.
HEAVY=DUTY EDGE GUIDE (SOLD SEPARATELY)
An edge guide can be used as an aid in
routing applications such as decorative
edging, straight edge planning and trimming,
grooving, dadoing and slotting.
To attach the edge guide to the plunge base,
simply insert the edge guide rods into edge-
guide mounting slots either from the left or the
right.
Tighten the lever on the left by turning it
counterclockwise to secure the edge guide
until it touches the rod (Fig.19).
Tighten the lever on the right by turning it
clockwise to secure the edge guide until it
touches the rod (Fig.19a).
NOTE: If the inner screws wear down or
require calibration, pull the lever up and turn
it clockwise and then push the lever down
(Fig. 19b).
• Turn the lever counterclockwise to secure
the edge guide (Fig.19c).
Fig. 18
Two screws included
Fig. 19
Fig. 19a
Fig. 19b
27666 ManuaLRevised_11-0114 Page 27