SET UNIT AND ALTITUDE
You can set the barometric unit of measurement (mb /
hPa or inHg) and altitude. Doing this allows the product
to take more accurate barometric measurements.
1. Press PRESSURE to select the unit of
measurement: mb / hPa or inHg.
2. Press and hold PRESSURE for 2 seconds.
3. Select the altitude (-100 to 2500 metres) in
increments of 10). Press
or
to change the
setting. Press PRESSURE to confirm.
WEATHER FORECAST
This product forecasts the next 12 to 24 hours of weather
within a 30-50 km (19-31 mile) radius with 70 to 75
percent accuracy. The weather forecast is always
displayed.
SUNNY
PARTLY
CLOUDY
RAINY
CLOUDY
TEMPERATURE AND HUMIDITY
This product can display current, minimum, and maximum
temperatures and humidity percentage information
collected by the remote sensors and main (indoor) unit.
Outdoor data is collected and displayed every 40 seconds.
Indoor data is collected and displayed every 10 seconds.
SELECT TEMPERATURE UNIT
°
°
Slide the
C /
F switch into the desired location. The
switch is located on the front button panel. The setting for
the main unit overrides the remote sensor setting.
SELECT CHANNEL NUMBER
Press CHANNEL to switch between sensors 1-3.
The icon shows the selected sensor.
KINETIC-
WAVE
ICON
DESIG-
Indoor
Remote
Remote
Remote
NATED
Display
Display
Display
Display
DISPLAY
Channel 1 Channel 2 Channel 3
To auto-scan between sensors, press and hold
CHANNEL for 2 seconds. Each sensor's data will be
displayed for 3 seconds. To end auto-scan, press
CHANNEL or MEMORY.
NOTE If you use a sensor that collects only temperature
data, humidity will not be shown.
NOTE For more information on the sensor see "Remote
Sensor THGR122NX" Section.
Page 6