ABOUT OREGON SCIENTIFIC Wireless Visit our website (www.oregonscientific.com) to learn more about other Oregon Scientific products such as digital cameras, hand-held organizers, health and fitness gear, and projection clocks. The website also includes contact information for our customer service department, in case you need to reach us.
PRODUCT OVERVIEW FRONT VIEW BAR608HGA lab test R2 SNOOZE / LIGHT button Weather Forecast & Barometric Trend Area Outdoor Temperature & Humidity Area Indoor Temperature & Humidity Area Clock / Alarm Area Moon Phase : increase or decrease setting / activate or deactivate Atomic Clock.
GETTING STARTED BATTERIES Batteries are not supplied with this product. You will need to purchase 3 x UM-3 (AA) 1.5V alkaline batteries for the main unit, and 2 x UM-4 (AAA) 1.5V alkaline batteries for the remote sensor. Insert batteries before first use, matching the polarity as shown in the battery compartment.
SETUP SENSOR Open the remote sensor battery compartment with a small Phillips screwdriver. Insert the batteries, matching the polarity as shown in the battery compartment. SWITCH OPTION Channel Channel 1 - 3. If you are using more than one sensor, select a different channel for each sensor.
DATA TRANSMISSION Data is sent from the sensor(s) every 40 seconds. The reception icon shown in the Temperature and Humidity Areas show the status. ICON DESCRIPTION Main unit is searching for sensors. At least 1 channel has been found. Channel 1 is selected (number will change depending on the sensor you select) --- shows in Outdoor...
TURN ATOMIC CLOCK ON/OFF Perform this step if you cannot receive Atomic Clock signals. Press and hold DOWN for 2 seconds. Then, manually set the clock following the "Set Clock" instructions (below). The signal icon indicates that the Atomic Clock feature is ON.
If no button is pressed, the Alarm will automatically silence after 2 minutes. It will then sound again after 8 minutes. BAROMETER This product tracks barometric pressure changes over the past 24 hours to provide the weather forecast 13) and a trend line showing the direction of barometric change.
TEMPERATURE AND HUMIDITY This product can display current, minimum, and maximum temperatures and humidity percentage information collected by the remote sensors and main (indoor) unit. Outdoor data is collected and displayed every 40 seconds. Indoor data is collected and displayed every 10 seconds.
NOTE When you press RESET, all settings will return to default value, and you will lose all stored information. SAFETY AND CARE Clean the product with a slightly damp cloth and alcohol- free, mild detergent. Avoid dropping the product or placing it in a high-traffic location.
Problem Symptom Remedy Cannot Check sensors. Only Remote one sensor is working sensor change channel Data does Initiate a manual sensor not match search ( main unit BAR608HGA lab test R2 SPECIFICATIONS MAIN UNIT DIMENSIONS L x W x H Weight REMOTE SENSOR DIMENSIONS L x W x H...
RELATIVE HUMIDITY Range 25% to 95% Resolution Memory Minimum / maximum BAROMETER Unit mb/hPa or inHg Range 700 to 1050 mb (20.67 to 30.01 inHg) Resolution 1 mb (0.03 inHg) Altitude -328 to 8203 feet Display Rainy, cloudy, partly cloudy, sunny REMOTE SENSOR (THGR122NX) RF frequency 433 MHz...
FCC STATEMENT This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.
Page 17
Please call our customer service number (listed on our website at www.oregonscientific.com, or on the warranty card for this product) for all inquiries instead. Name: Oregon Scientific, Inc. Address: 19861 SW 95 Tualatin, Oregon 97062 USA Telephone No.: 1-800-853-8883 Fax No.:...