Getting Started; Batteries; Access Front Button Panel; Change Settings - Oregon Scientific BAR629HG User Manual

Weather system pro

Hide thumbs

Table Of Contents

Table of Contents

GETTING STARTED

BATTERIES

Batteries are supplied with this product:

• Main unit

3 x UM-3 (AA) 1.5V batteries

• Remote unit

2 x UM-4 (AAA) 1.5V batteries

Insert batteries before first use, matching the polarity

(+ and -) as shown in the battery compartment. For best

results, install batteries in the remote sensor before the

main unit. Press RESET after each battery change.

NOTE Do not use rechargeable batteries.

shows when batteries are low.

NOTE It is recommended that you use alkaline batteries

with this product for longer performance.

UNIT

Main

Remote

Installing the batteries:

ACCESS FRONT BUTTON PANEL

The front button panel is located inside the right portion

of the main unit. Slide it right to access the buttons.

CHANGE SETTINGS

To change, time, calendar and language settings:

1. Press and hold MODE for 2 seconds to enter setting

mode.

2. Press

to change settings. (To reach the

setting you want quickly, press and hold

3. Press MODE to confirm.

LOCATION

Indoor Temperature /

Humidity Area

Outdoor Temperature /

Humidity Area

TABLE STAND OR WALL MOUNT

Use the stand on the back of the main unit / remote

sensor, or mount it on a wall with a nail.

To attach the main unit stand:

To use the main unit wall mount:

To use the remote sensor stand or wall mount:

REMOTE SENSOR (THGR122NX)

This product is shipped with a THGR122NX Thermo /

Hygro Sensor that collects Temperature and Humidity

data. Data can be collected from up to 3 sensors.

Additional sensors sold separately.

SETUP SENSOR

1. Open the remote sensor battery compartment with a

small Phillips screwdriver.

2. Insert the batteries, matching the polarity (+ and -) as

shown in the battery compartment.