Removing The Blade; Led Worklight; Live Tool Indicator Light - Craftsman 320.17235 Operator's Manual

TOOL-LESS BLADE INSTALLATION cont.
6. Pull down on the blade to make sure the blade is securely locked in place.
7. Attach the clear chip shield into its mounting slots and snap the shield down to its
proper position.
NOTE: For use with both "T" and "U" shanked blades.
CAUTION:
Once the blade is installed in the saw, it is always exposed.
There is no lower blade guard. Use caution when handling the saw so that the
blade does not catch clothing, skin, etc. Each time you set the saw down take
care not to bend the blade. Always set saw down on its side when blade is
installed. ALWAYS remove blade when saw is not being used.
REMOVING THE BLADE
1. Unplug the saw.
/_ WARNING:
ALWAYS unplug saw from the power source before
changing blades or making any adjustments. Failure to unplug the saw could
result in accidental starting which can cause serious personal injury.
2. Follow steps 1 through 4 on the tool-less blade installation (see pages 13 and 14).
3. Carefully remove the blade (or change the blade).
4. Reattach the clear chip shield and snap it down to its proper position.
I NOTE: When storing saw, ALWAYS remove the cutting blade.
your
I
LED WORKLIGHT (Fig. 8)
Your sabre saw has an LED worklight that
turns "ON" automatically when the saw is
plugged into a power source. The light helps
provide easy visibility of the cutting line.
..- ..
"LIVE TOOL INDICATOR" LIGHT (Fig. 9)
Your saw has a "Live Tool Indicator" green
light that turns "ON" automatically when the
saw is plugged into a power source. The
light is located on both sides of the base of
the trigger-switch handle near the body of
the saw.
14