Craftsman 320.16491 Operator's Manual page 48

ADJUSTING THE EXTENSION
BARS (Fig. 17)
1. Extend the extension bar to the
required position to properly
support the workpiece.
2. Fully tighten the two extension-
bar locking knobs (J).
I Fig. 17
A
WARNING: When servicing, use only identical replacement parts. Use of any
other parts may create a hazard or cause product damage.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most plastics are susceptible
to damage from various types of commercial solvents and may be damaged by
their use. Use clean cloths to remove dirt, dust, oil, grease, etc.
_, WARNING: When servicing, use only identical replacement parts. Use of any
other parts may create a hazard or cause product damage. To ensure safety and
reliability, all repairs should be performed by a qualified service technician.
WARNING: Keep the miter saw stand dry, clean, and free from oil and
grease. Always use a clean cloth when cleaning. Never use brake fluids,
gasoline, petroleum based products or any strong solvent to clean the stand.
Chemicals can damage, weaken or destroy plastic which may result in serious
personal injury.
NOTICE: If the mounting bracket
requires adjustment to mount
securely on your stand:
* Release the nut by turning
it counterclockwise.
Tighten the Phillips Screw
by turning it clockwise, and
tighten the nut by turning
it clockwise.
Fig. 18
Phillips Screw
16491 ManuaLRevised_12 0606 Page 13