Advertisement
A
_& WARNING:
Do not use this stand as scaffolding
or as a ladder. Make sure
to tighten the locking knob securely
prior to use. Maximum capacity
is 330 Ibs.
Power tools on the stand should
not exceed a combined
overall height of 60
inches from the floor.
UNFOLD THE WORK LEGS
1.
Place the frame assembly with
legs (A) upside down on a flat
surface as shown in Fig. 2.
Fig. 2
2.
Open the top two legs, press the
locking pins and rotate the legs
until the locking pins snap into
the open position and you hear a
"click" to signal that the legs are
locked in place (Fig. 3).
3.
Open and lock the other two
legs the same way.
4.
Place the frame assembly on
a flat surface as shown
in Fig. 4.
Press locking
3in to move leg
F'
Page 10
16492
ManuaLRevised_12
0528
Advertisement
