Advertisement
4.
Tighten the locking lever to
lock the mounting
brackets
(B) (Fig. 8).
Mounting Non=Standard
Miter Saws
Locking
lever
_,
WARNING:
Do not mount
a table saw on this stand. The
direction
of feed on a table saw
is perpendicular
to the axis of
stability on this stand. Aggressive
feeding
of sheet materials
into a
table saw could cause the stand to tip over.
NOTICE: This configuration
allows for miter saws on which the 4 mounting
holes
form a trapezoid
pattern (some saws) and those on which the 3 mounting
holes
form a triangular
pattern (few saws).
Install the two support
bars (C) onto the mounting
brackets
(B).
Fig. 9
G
J
1.
Place the two support
bars
(C) on the mounting
brackets
(B). Use screws (H), washers
(J), self-locking
washer (F)
and nuts (G) to pre-tighten
the support
bars (C) on the
quick-release
mounting
brackets
(B) (Figs. 9 and 10).
Fig. 10
B
C
Two support bars (C) installed on mounting
brackets (B)
Page 12
16492
ManuaLRevised_12
0528
Advertisement
