Table of Contents
Advertisement
Receiver and Remote Control Programming
[To comply with FCC rules, adiustment
or modifications
of this receiver
an(i/or transmitter are prohibited, except fo_ changing the code setting or
replaclngpARTS,
the battery. THERE
ARE NO OTHER
USER SERVICEABLE
Models with 3-function remote controls:
The
remote controls have been factory set to operate
with the large push button on the remote control.
However, you can use either of the two small
buttons, if you prefer. And, the 3-function remote
control can also activate additional garage door
openers and/or light controls.
Below are instructions for programming your opener
to match the other buttons on your remote controls
and any additional remote controls you may
purchase. See available accessories on page 38:
53000SRT Series Garage Door Opener's
(With "SRT" Button)
Children
operating
or playing
with • garage
door opener can Injure themselves
or others.
The garage
door could
close
and cause
serious injury or death. Do not allow children
to operate the door push button(s) or remote
control(s).
A moving
garage
door could injure
or kill
someone
under it. Activate
the opener only
when you can see the door clearly, it is free of
obstructions, and is properly adjusted.
Figure I
Selecta remotecontrolpush
buttontoeperate opener
Your =SR'T"garage door opener will operate with as
many as four =SR'I" portable remote controls and
one Multi-Function Keyless EnVy.
To Add A Remote Control
1. Press and holdthe selected remote control push
button, sea Figure 1.
2. Then press and release the "SRT" (learn) button
on the right side panel of the opener, Figure 2.
The opener lights will flash once.
3. Release the remote push button.
Now the opener will operate when the remote
control push button is pressed.
If you release the remote control push button
before the opener.lights flash, the opener will
not accept the code.
To Change the Selected Push Button
On the Same Remote control
If you decide to use a different remote control button
than originally programmed into the opener, you
must erase allthe learned codes and reprogram
each remote control used to operate the garage
door opener.
To Erase All Remote control Codes
• Press and hold the "SR'I" button on the opener
panel until the indicator light turns off (about 6
seconds). Aflthe codes the opener has learned
will be erased.
• To reprogram, repeat Steps 1,2 and 3 for each
remote control in use.
Code programming Instructions are also located
on the opener panel.
3-Function
Remote Control
Figure 2
Garage Door Opener
(With "SRT" Button)
"SRT" (learn)
Indicator
RIGHT
Button
Light
PANEL
To Add the Keylese Entry
We recommend that you program your code before
you install the Keyless Entry. You will not need
assistance, and you can test the reception at the
mounting location before installation.
1. Choose a 4-digit coda using numbers from 0 to 9.
You can use a number more than once (for
example, 4, 0, 4, 1). Press the selected code digits
on the keypad.
2. Press and holdthe Enter button while you press
the =SRI"* (learn) button on the opener panel. The
indicator light will blink and the door will begin to
move.
3. Release the Enter button. Now the opener has
learned the selected keypad cede.
To ensure that your portable remote control codes
were not disturbed while you were programming the
Keyless Entry, test your remotes and reprogram them
if necessary.
To change the code at any time, repeat steps 1-3.
33
Advertisement
Table of Contents
