Table of Contents
Advertisement
Installation
Step 6
I
Install the Door Control
.ocate the door control within sight of the door
at s minimum height of 5 feet where small
children cannot reach, and away from all moving
parts of the door and door hardware.
The door control is typically attached directly to the
wall. If installing into drywall, drill 5/32" holes and
use the anchors provided.
1. Strip 1/4" of insulation from one end of the bell
wire and connect it to the two terminal screws on
the back of the door control: white to 2, and
white/red to 1.
2. Fasten the Door Control Button securely with
6ABxl-1/2"
screws.
3. Run the bell wire up the wall and across the
ceiling to the opener. Use insulated staples to
secure the wire in several places. Be careful not
to pierce the wire with a staple, creating a short.
4. Connect the bell wire to the terminal screws on
the opener panel: white to 2; white/red to !.
5. Position the antenna wire as shown.
6. Attach the User Safety Instruction label to the
wall near the door control, and the Maintenance
;nstruction label in a prominent location on the
inside of the garage door.
Page 32 explains how to use the door control.
Do not connect to live electWcal wiring. Connect
only to 24 Volt low voltage wires. Connection to
live wires or higher voltage may cause serious
injury from shock, burn or electrocution.
Children
operating
or playing with a garage
door opener can injure themselves or others.
The garage
door
could
close
and cause
serious injury or death.
Install the door control (or any additional push
buttons) out of the reach of children and away
from all moving
parts of the door and door
hardware, but where the garage door Is visible.
Do not allow
children
to operate
the push
button(e) or the remote control(s).
A moving garage door could injure someone
under it. Activate
the opener only when the
door is properly adjusted, you can see It clearly,
and there are no obstructions to door travel.
Do NOT connect
the power and operate
the
opener at this time. The trolley will travel to the
full open position
but will not return to the
close
position
until
the sensor
beam
Is
connected and properly aligned.
Sea Safety
Reversing
Sensor
Instructions
beginning on page 21.
Hardware
Shown
Actual
Size
Insulated Staplee
_] 111tlilJllllllllllillllililtltl_>
6ABxI-Ii2" Screw
Door ControlButton
Dry Wall Anchors
2-Conductor
Op_er
BeNWire
Terrnk_l Sinews
DOOR CONTROL
SUTTON ( SACK)
2-Conduct<x
Bel Wire
I
Screws
DCOR
CONTROL
BUTTON
18
Advertisement
Table of Contents
