Receiver And Remote Control Programming - Craftsman 139.53525SRT Owner's Manual

Receiver and Remote Control Programming

To comply with FCC rules, adjustment or modifications of this receiver
and/or transmitter are prohibited, except for changing the code setting or
replacing the battery. THERE ARE NO OTHER USER SERVICEABLE
PARTS.
Your 53000SRT series garage door opener (with
receiver "SRT" button) has been factory set to
operate with the large push button on the remote
control(s). However, you can use either of the two
small buttons, if you prefer. And, the 3-function
remote control(s) can also activate additional
garage door openers and/or light controls.
Below are instructions for programming your opener
to match the other buttons on your remote controls
and any additional remote controls you may
purchase. See available accessories on page 38.
53000SRT Series Garage Door Openers
(With "SRT" Button)
Your "SRT" garage door opener will operate with as
many as four "SRT" portable remote controls and
one Multi-Function Keyless Entry.
To Add A Remote Control
1. Select a remote control push button to operate
the receiver.
2. Press and hold the selected remote control push
button, Figure 1.
3. Then press and release the "SRT" button on the
right side panel of the opener in Figure 2. The
opener light will flash once.
Now the opener will operate when the remote
control push button is pressed.
If you release the remote control push button
before the opener light flashes, the opener will
not accept the code.
To Change the Selected Push Button
On the Same Remote control
If you decide to use a different remote control button
than originally programmed into the opener, you
must erase all the learned codes and reprogram
each remote control used to operate the garage
door opener.
To Erase All Remote control Codes
• Press and hold the "SRT" button on the opener
panel until the indicator light turns off (about 6
seconds). All the codes the opener has learned
will be erased.
• To reprogram, repeat Steps 1, 2 and 3 for each
remote control in use.
Code programming instructions are also located
on the opener panel.
Children operating or playing with a garage
door opener can injure themselves or others.
The garage door could close and cause
serious injury or death. Do not allow children
to operate the wall push button(s) or remote
control(s).
A moving garage door could injure or kill
someone under it. Activate the opener only
when you can see the door clearly, it is free of
obstructions, and is properly adjusted.
Mini 3-Function
Remote Control
Select a remote control push
button to operate opener
Standard 3-Function Remote Control
Garage Door Opener
(With "Smart" Button)
1
"SRT"
Indicator
Button
33
WARNING
2 3
9 9
1 1
7 3 7 3
5 5
KG
KG
Light
END PANEL
Figure 1
Figure 2