Position The Opener - Craftsman 139.53663SRT Owner's Manual

Installation Step 5
Position the Opener
Follow instructions which apply to your door type
as illustrated.
SECTIONAL Door or ONE-PIECE Door with Track
A 2x4 laid flat is convenient for setting an ideal door-
to-rail distance.
• Raise the opener onto a stepladder
You will need help at this point if the ladder is not tall
enough.
• Open the door all the way and place a 2x4 laid flat on
the top section beneath the rail.
If the top panel hits the trolley when you raise the door,
pull down on the trolley release arm to disconnect the
inner and outer sections. The trolley can remain
disconnected until Step 13 is completed.
Rail 2x4
Foam
Packaging
_Trotley
ReIease Arm
ONE-PIECE Door without Track
• With the door fully open and parallel to the floor,
lneasure the distance from the floor to the top of the
door.
• Using a stepladder as a support, raise the opener to the
same distance as the door froln the floor (it will be at a
slight angle as shown).
• The top of the door should be level with the top of the
opener. Do not position the opener more than 3" above
this point.
Header
Bracket
Top of Door
Top of Opener
Packaging
19