Kitchen Timer - GE JB705TT1CC Owner's Manual

Using the clock, kitchen timer, and control lockout. GEAppliances.c
To Set the Clock
The clock must be set to the correct time of day
for the Delay Start functions to work properly.
The time of day cannot be changed during
a delayed cooking or a delayed self-cleaning
cycle.
Touch the CLOCKpad.
Touch the number pads until the correct
time of day is shown in the display. If the
number pads are not touched within one
minute after you touch the CLOCKpad,
the display reverts to the original setting. If
this happens, touch the CLOCKpad and
enter the time of day.
r_ Touch the STARTpad until the time of day
shows in the display.This enters the time
and starts the clock.
To check the time of day when the display is
showing other information, touch the CLOCK
pad. The time of day shows until another pad
is touched. To change the time format or turn
off the clock display, see the SpecialFeatures
section.
TIMER
ON
TIMER ]
OFF
The KitchenTimer is in hours and
minutes.
TheKitchenTimerdoesnot controloven
operations. T hemaximum settingon the
KitchenTimeris9 hoursard 59 minutes.
To Set the Kitchen Timer
%
[]
Touch the TIMER ON pad.
Touch the number pods until the amount
of time you want shows in the display. For
example, to set 2 hours and 45 minutes,
touch 2, 4 and 5 in that order. If you make
a mistake, touch the TIMEROFFpad and
begin again.
r_ Touch the STARTpad.
After touching the STARTpod, SET
disappears;this tells you the time is counting
down, although the display does not change
until one minute has passed.Seconds will not
be shown in the display until the lust minute is
counting down.
r4] When the kitchen timer reaches :00, the
control will beep 3 times followed by one
beep every 6 seconds until the TIMEROFF
pad.
The 6-second tone can be cancelled by
following the steps in the Specialfeatures of
your oven control section under Tones at the
End of o Timed Cycle.
To Reset the Kitchen Timer
If the display is still showing the time remaining,
you may change it by touching the TIMERON
pad, then touching the number pads so that the
time you want appears in the display.
If the remaining time is not in the display (clock,
delay start or cooking time are in the display),
recall the remaining time by touching the
TIMERON pad and then touch the number
pads to enter the new time you want.
] To Cancel the Kitchen Timer
TIMER TIMER Touch the TIMEROFF pad.
ON OFF
How to Lock Out the Controls (on some models)
Control Lockout will allow you to lock out the
touch pads so they cannot be activated when
touched. Some models have Range Lockout
which will also turn off the surface units.
To lock/unlock the controls:
% Touch and hold the Control Lockout or
Renge Lockout pad for 3 seconds. For
some models,you have to touch and hold
the 9 and 0 pads at the same time for 3
seconds. A light will turn on indicating the
controls are locked out.
To unlock the control, Touch and hold the
Control Lockout or Renge Lockout pad
for 3 seconds. For some models, you hove
to touch and hold the 9 and 0 pads at the
same time for 3 seconds. The light will
turn off indicating the controls are
unlocked.
When this feature is on, the touch pads will not
respond except for the Cleer/Off pad.
The adjustment will be retained in memory
after a power failure.
11