Craftsman 320.16489 Operator's Manual page 10

Step 2
Installing the Roller
(Fig. 3 and Fig. 4)
1. Place the stand on a flat
surface. Position the roller (C)
onto the height-adjustment
bar (G). Use two screws (H),
two washers (J) and two
nuts (I) to mount the roller
onto the height-adjustment
bar (G) as shown in Fig. 3.
2. Hold the nuts (I) with the hex
key (supplied), and tighten the
screws (H) with an open-end
wrench (not supplied) (Fig. 4).
Step 3
Adjusting Height (Fig. 5)
WARNING: Before using
the roller stand, check that all
screws and the locking lever are
securely tightened.
1. Loosen the locking lever by
turning it counterclockwise.
2. With one foot on the stand
foot, carefully raise or lower the
roller, to the proper position,
according to the height of the
worktable of your power tool
(Fig. 5). Tighten the locking
lever by turning it clockwise.
Fig. 3
G
J
I
Fig. 4
C
H
Page 10 16489 ManuaLRevised_12 0525