GE Profile UPVH890 Owner's Manual And Installation Instructions page 47

GEAppliances.com
PROBLEM Possible Causes What To Do
Clothes shrink Some fabrics will naturallg shrink •
when washed. Others can be
safelg washed, but will shrink
in the drger •
To avoid shrinkage, follow garment care labels exactly.
Some items may be pressed back into shape after drying.
If you are concerned about shrinkage in a particular
item, do not machine wash or tumble dry it.
Greasy spots on clothes Improper use of fabric softener • Follow directions on fabric softener package.
Drging dirtg items • Use your dryer to dry only clean items. Dirty items can
with clean ones stain clean items and the dryer.
Clothes were not • Sometimes stains which cannot be seenwhen the
completelg clean clothes are wet appear after drying. Use proper washing
procedures before drying.
Lint on clothes Lint filter isfull • Clean lint screen before each load.
Improper sorting • Sort lint producers (likechenille)from lint collectors
(likecorduroy).
Static electricity can attract lint • See suggestions in this section under STATIC
Overloading • Separate large loads into smaller ones.
Paper, tissue, etc., left in pockets • Empty all pockets before laundering clothes.
Static occurs No fabric softener was used • Try a fabric softener.
Bounce®Fabric Conditioner Dryer Sheets have been
approved for use in all GEDryers when used in
accordance with the manufacturer's instructions.
Overdrging
Sgnthetics, permanent press
and blends can cause static
• Try o fabric softener.
• Adjust setting to LESS DRYor DAMP.
• Try a fabric softener.
Collars and waistbands
still wet at end of cgcle
The drgness monitor senses
that the bodg of the clothes
is drg
• Choose SPEEDDRYor TIMEDDRYto dry damp collars
and waistbands. In the future, when drying a load with
collars and waistbands, chooseMOREDRY
Slight variation
in metallic color
This is normal
• Dueto the metallic properties of paint used for this unique
product, slight variations of color may occur due to
viewing angles and lighting conditions.
Door is too foggy to see
clothes during a steam
cycle
Steam condenses on inner door • This is normal.
Water seen on inside of
door and top of tint filter
when opening door after
steam cycle
Steam condenses on these
surfaces
• This is normal.
Small areas on clothes are Steam condenses on inner drum • Select a shorter cycle.
damp after steam cycle
Cgcle or cgcle time selected too • Hanually reduce cycle time for given cycle.
long for size of loud
47