GE Profile UPVH890 Owner's Manual And Installation Instructions page 44

Installation Instructions
INSTALLINGTHE PEDESTAL(if desired)(cont.)
LEVEL THE WASHER OR DRYER
rA1 Stand the washer or dryer upright. Move it
close to its final location.
rB1 Make sure that the washer or dryer is level
by placing a level on top. Check side to side
and front to back.
[]
Use an open
ended wrench
to adjust the
legs in and out.
Tighten the lock
nut against
the bottom
of the pedestal.
/
/
/
NOTE: To minimize vibration, the locking nuts
must be tight.
I-_ REMOVE SHIPPING SCREWS
Remove the 4 shipping screws on the back side
of the washer.
[71 FINALIZE THE INSTALLATION
Refer to the washer or dryer Installation Instructions
to complete the installation.
r_
re]
@
REINSTALL THE DRAWER
Check to
be sure the
slides are
closed.
Slide the
drawer
into the Drawer
opening.
Align the
drawer
supports to the
slides on each
side.
Reinstall the original screws into each drawer
slide. Tighten both screws.
Open the drawer fully. Slide drawer divider
into slots in the center of the drawer. The
drawer should slide smoothly when you push
it closed.
44