GE Profile UPVH890 Owner's Manual And Installation Instructions page 35

Installation Instructions
BEFORE YOU START
Unplug the dryer from its electrical outlet.
[] REMOVE THE DOOR ASSEMBLY
Remove the side hinge cap by opening
the dryer door and removinc the screw from
behind the hinge (#8 x .375" tapping screw). Then
using your hand, pop the hinge cap off the dryer.
IxC
/
o
Hinge
l_l REMOVE THE DOOR ASSEMBLY (cont.)
Hold the door and remove the 2 hinge screws
(#10 x 0.75" tapping screws). Pull the door away
from the dryer front panel.
i
i
/ i
r2l DISASSEMBLE THE DOOR ASSEMBLY
Lay the door down on a soft, protected, flat
surface so that the inner part faces upward
(door resting on the handle side).
Remove the 7 screws (#10 x 1.125" tapping
screws) located around the perimeter of the door.
Turn the door assembly over and separate
the chrome cover from the inner door. Put
the inner door aside on a soft, protected flat
surface.
35