Advertisement
Available languages
Available languages
4. FirstconnectREDbatterycable (B)to
positive(+)batteryterminalwith hex
bolt andkeps nut as shown.Tighten
securely.Slideterminalcover (C) over
terminal.
5. ConnectBLACKgroundingcableto
negative(-) batteryterminalwith re-
maininghex boltand kepsnut.Tighten
securely
6. Close hood.
Negative
(Black)
Cable
TO REPLACE
HEADLIGHT
BULB
1. Raise hood.
2.
Remove
bulb holder from the hole in
the backside
of the grill.
3.
Replace
bulb in holder and install bulb
holder securely
back into the hole in
the backside
of the grill.
4.
Close hood.
INTERLOCKS
AND RELAYS
Loose or damaged
wiring
may cause
your tractor to run poorly, stop running,
or
prevent
it from starting.
• Check
wiring.
See electrical
wiring
diagram
in the Repair
Parts manual°
TO REPLACE
FUSE
Replace
with 20 amp automotive-type
plug-in fuse.
The fuse holder is located
behind the dash.
TO REMOVE
HOOD & GRILL ASSEMBLY
!.
Raise hood.
2o Unsnap
headlight
wire connector.
3.
Stand in front of tractor°
Grasp hood at
sides, tilt toward
engine and lift off of
tractor.
4.
When replacing
hood, be sure to re-
connect
the headlight
wire connector.
_Hood
ENGINE
TO ADJUST
THROTTLE
CONTROL
The
throttle
control
has
been
preset
at
the factory
and adjustment
should
not be
necessary
Check
adjustment
as described
below before loosening
cable, tf adjustment
is necessary,
see engine manual.
TO ADJUST
CHOKE
CONTROL
The choke control
has been preset
at the
factory and adjustment
should not be neces-
sary. If adjustment
is necessary,
see engine
manual.
TO ADJUST
CARBURETOR
Your carburetor
has been preset at the factory
and adjustment
should
not be necessary.
However, minor adjustment
may be required
to compensate
for differences
in fuel, tem-
perature,
altitude or load.
If the engine does
need adjustment,
see engine
manual
Immediately
prepare your tractor for storage
at the end of the season
or if the tractor will
not be used for 30 days or more.
,AWARNING:
Never store the tractor
with
gasoline
in the tank inside a building where
fumes
may reach an open flame
or spark.
Allow the engine
to cool before
storing
in
any enclosure.
TRACTOR
When
tractor
is to be stored
for a period
of time, clean it thoroughly,
remove
all dirt,
5.
grease, leaves, etco Store in a clean, dry area.
26
1. Clean entire tractor (See"CLEANING"
in
the Maintenance
section
of this manual).
2o lnspectand
replacebelts,
ifnecessary
(See
belt replacementinstructionsin
the Service
and Adjustments
section of this manual).
3.
Lubricate
as shown in the Maintenance
section
of this manual.
4.
Be sure that all nuts, bolts and screws
are securely
fastened.
Inspect
moving
parts for damage,
breakage
and wear.
Replace
if necessary.
Touch
up alt rusted
or chipped
paint
surfaces;
sand lightly before painting.
Advertisement
