Advertisement
Aligntheholesinthehandle withtheholes inthe
bottom Of
the poly tray, the latch stand plate and the
latch stand bracket. Fasten together using four 1/4" x
2" hex bolts, 1/4" fiat washers and 1/4" (SEMS) hex
nuts as shown in figure 9. Tighten.
At this time tighten all bolts which were leR loose.
1/4" X 2"
.
' HEX BOLT
1/4" HEX
"_--_NUT (SEMS) "_''?
,'
FIGURE 9
Assemble the tool holder bracket inside the front of
the poly tray using two 1/4=x 3/4" hex bolts, two 1/4"
fiat washers and two 1/4" (SEMS) type hex nuts.
Tighten.
See figure 10.
1/4" HEX
1/4" x 3/4"
NUT (SEMS)
HEX BOLT
=TOOLHOLDER
BRACKET_
1/4"FLAT
WASHER
FIGURE 10
7
Advertisement
