Download Print this page

Poly Tray - Craftsman 486.24385 Owner's Manual

Utility 10 poly convertible cart
Hide thumbs

Advertisement

o. Assemble a 3/4" fiat washer, a wheel with the valve
stem facing out, and another 3/4" fiat washer onto
the axle. Insert a cotter pin through the axle,
spreading the ends so that a hub cap can fit over
the cotter pin. Assemble a hub cap by pressing it
onto the 3/4" fiat washer. Repeat on other end of
axle. See figure 6.
WHEEL
314" FLAT
WASHER
\
AXLE
_,_
3/4" FLAT
WASHER
CO'I-rER PIN
FIGURE 6
FIGURE 7
STAND
PLATE
5/16" x 3/4"
TRUSS HEAD
BOLT
6/16" HEX
NUT (SEMS)
LATCH STAND
BRACKET
Turn the wheel support over to the upright position.
Place the latch stand bracket down between the latch
lock assembly and the raised tab on the tongue.
Place the poly tray down to rest on the wheel support
and latch stand bracket. Fasten the tray to the wheel
support using eight 5/16" x 3/4" truss head bolts and
5/16" (SEMS) hex nuts. Do not tighten yet. See
figure 7.
Place the latch stand plate between the latch stand
bracket and the poly tray. See figure 7.
Insert two 1/4" x 1-3/4" hex bolts through the handle
tube as shown in figure 8. Holding the bolts in place
in the handle, insert the bolts through the holes in the
poly tray, allowing the legs of the handle to slip
beneath the latch stand bracket. Secure the two bolts
with two 1/4" fiat washers and 1/4" (SEMS) hex nuts.
Do not tighten yet. See figure 8.
1/4" HEX
1/4" FLAT
NUT (SEMS)
WASHER
1/4" x 1-3/4"
HEX BOLT
LATCHSTAND
BRACKET
FIGURE 8

Advertisement

loading

  Related Manuals for Craftsman 486.24385