Care and Cleaning
Unplug the beverage
If the unit is in a built-in
remove power at the circuit
Unplug the beverage center before
cleaning. If the unit is in a built-in
remove power at the circuit breaker. Use a
slightlg damp cloth or sponge when cleaning
around switches, lights or controls.
Usewarm water and baking soda solution-
about a tablespoon (15 ml) of baking soda to
a quart (! liter) of water. This both cleans and
neutralizes odors. Thoroughly rinse and
Other parts of the beverage center unit-
including the door gaskets, full extension
drawers and glass shelves-can
the same wag.
Avoid cleaning cold glass shelves with hot
water because the extreme temperature
mall cause them to break. Handle
glass shelves carefully.
Rough handling of
tempered glass can cause it to shatter.
Periodically check the drain hole and
channel for any debris, If the drain is blocked,
will not drain properly,
To check and clean the drain hole, remove
the bottom two glass shelves. Sweep a damp
cloth along the channel in the back of the
beverage center. Use a finger to sweep
awag ang debris from the drain hole.
Appearance may vary