Controls and Features
two full extension drawers hold
five bottles each and are loaded with necks
facing the rear. Tall bottles should not be
loaded on the bottom drawer because they
may prevent the door from closing.
• Do not block the thermistor,
side, just above the third
shelf of the beverage center. Blocking the
could impair the air circulation
NOTE: This unit is for storing beverages only
and not intended for the storage of
out so bottles can conveniently
The upper full extension slide can be
removed for magnums
or larger bottles.
1. Pull the full extension
drawer out to the
2. Push the tab on right drawer guide down
while pulling the tub on left guide up, and
pull the drawer out.
1. Push the drawer slide arm buck into
2. Pull the small slide sub-assembly
3. Insert the sides of the drawer back
into the guides.
4. Push until the tabs lock into place.
Appearance may vary
Tab (push tab down on right
drawer guide, pull tab up on
left drawer guide/
To replace, push drawer slide
Pull small slide sub-assemblg
arm back into unit
NOTE: Make sure the tabs on the full
drawer guides are fully engaged
before loading any bottles. Pull the drawers
out all the way to the STOP position and
push back in several times to make sure
locking tabs are properly engaged.
The full extension
drawer fronts on the
center are unfinished
wood. During use, oil from hands may
and stain the wood.
• The drawer fronts may be stained and
sealed to match adjacent cabinetry, The
tinted glass will make the stained wood
appear darken A true color match can be
seen only when the door is opened.
• Apply the stain and sealer according
odor, keep the door open to
and allow the stain/sealer
before using the product.
NOTE: Natural wood may vary slightly in
grain and colon