GE Monogram ZDBR240 Owner's Manual page 11

Care and Cleaning
Beverage Center
For your
safety
Unplug the beverage center before cleaning. If the unit is in a built-in location,
remove power at the circuit breaker.
Cleaning
the outside
The exterior surfaces can be washed with
mild soap and water. Rinsethoroughlg with
clear water. Never use abrasive scouring
powders.
Do not use scouring pads, powdered
cleaners, bleach or cleaners containing
bleach because these products can scratch
and damage the finish.
Warrantg does not cover damage due to
improper cleaning methods.
Glass door
Use a glass cleaner or mild soap and water
and a soft cloth to clean the glass door.
Do not use ang abrasive powders.
Door gasket
The vingl gasket nag be cleaned with mild
soap and water, a baking soda solution or
a mild scouring powder. Rinse well.
After cleaning the door gasket, applg a thin
lager of paraffin wax or petroleum jellg to
the door gasket at the hinge side. This helps
keep the gasket from sticking and bending
out of shape.
Light bulb
replacement
Unplug the beverage center before
replacing the light bulb. If the unit is
in a builtdn location, remove power
at the circuit breaker.
To remove the light shield, push in the tab
on the left side of the shield and lower it.
Replace with a !5 watt appliance bulb.
In the event
of a power
failure
If the power fails, open the door as
infrequentlg as possible to maintain
the temperature.
Do not store or use gasoline or other
flammable vapors and liquids in the
vicinity of this or any other appliance.
Preparing
to move
Secure all loose items such as shelves and Be sure the beverage center stays in an
drawers bu taping them securelg in place to upright position during moving.
prevent damage.
!!