GE Monogram ZBD3500 Use And Care Manual page 18

Before You Call For Service
Dishwasher
Questions ?
Use this
problem
solT)er
PROBLEM POSSIBLE CAUSE WHAT TO DO
Cloudiness on
glassware
Combination of soft
water anti too much
detergent
.This is called etching anti is permanent.
To prevent this fl'om happening, use
less detergent if you have soft water. Wash
glassware in the shortest cycle that will get
them clean.
Water temperature
entering the dishwasher
exceeds 150°F.
.Lower tile water heater temperature.
Black or gray Alumimml utensils have .Remove marks with a mild, abrasive
marks on dishes rubbed against dishes cleaner.
Tea or coffee stains Yellow or brown film
on inside surfaces
White film on inside
surfaces
Dishes don't dry
Control panel
responded to inputs
but dishwasher never
filled with water
Dishwasher won't run
Steam
.Remove tile stain by hand, using a
solution of 1/2 cup bleach anti 3 cups
w_|rlll water.
JIWARNING
Before cleaning interior wait at least 20
rmnutes after a cycle for tile heating
element to cool down. Failure to do so
can result in burns.
An overall yellow or
brown fihn can be caused
by iron deposits in water
Hard water minerals
Low inlet water
temperature
Rinse agent dispenser
is emppy
Door latch may not be
properly seated
.A special filter in tile water supply line is
tile only way to correct this problem.
Contact a water softener company.
.To clean tile interior, apply dishwasher
detergent to a damp sponge. Wear
rubber gloves. Do not use any type of
cleanser other than dishwasher detergent
because it may cause foaming or sudsing.
.Make sure inlet water temperature is
correct.
.Select HI TEMP RINSE and/or
HEATED DRY Option.
.Check the rinse agent dispenser.
.(;all for set_,ice.
Fuse is blown, or tile
circuit breaker tripped
This is normal
.Replace fl.lse or reset circuit breaker.
Remove any other appliances from
tile circuit.
.T U resetting tile START/RESET pad.
.Steam comes through tile vent by tile
door latch during duing anti when water
is being pumped out.
18