GE Monogram ZBD3500 Use And Care Manual page 7

3. Options
The light above the selecmd pad will be ONto indicam which OPTION has been selecmd.
POWER
PRESOAK
HI TEMP RINSE
HEATED DRY
OFF
HEATED DRY
ON
LOCK
For use with heavily soiled and/or dried-on, baked-on soils. This option
MUST be selected PRIOR to starting the cycle. This option adds
16 rmnutes to the cycle time.
Turns on the heater in all prerinse anti final rinse cycles to help prevent
spotting on dishware. This option may be turned ON or OFFduring the
wash cycle.
Shuts offthe thTing heat options. Dishes air ttU naturally and energ T is
saved. You can prop the door open after the light goes ONnext to the
word (;LEAN which appears in the STATUS display for faster duing.
Turns the heater on for first thTing. This cycle will extend the time
to your wash cycle by 30 rmnutes. NOTE: Cannot be selected with
RINSE & HOLD cycle.
When the LOCK pad is touched r_4ce within 3 seconds, all pads become
inoperative. You can lock dm controls to prevent an?, selections fi'om being made.
Or you can lock the controls after you have started a Q_le or selected DELAY
START so the cycle or DELAY START is not intemlpted.
Children cannot accidentally start dishwasher by touching pads with this
option selected.
To unlock the dishwasher after it has been locked, touch the LOCK pad twice
within 3 seconds. The light above the LOCK pad will be ore
DELAY START You can delay the start of a wash cycle fbr up to 8 hours. Press and hold
the DELAY START pad to choose the number of hours you want to delay
tlle start of the cycle. The machine Mll count dtm_ and start mltomatically
at the correct time. NOTE: If you fbrget to lock the door a reminder signal
will beep until you do so.
RESET
To change a cycle after washing starts, touch the START/RESET pad to
cancel the cycle. After water is pumped out anti motor stops, you can
reprogrmn and restart the dishwasher.
4. Start
(;lose the door until it locks into place and touch the START/RESET pad to begin the cycle.
There is a time delay between start-up anti water fill so you will not hear any wash action right away.
The cycle is complete when the light is ONnext to the word (;LEAN in the STATUS display.
NOTE: The dishwasher remembers your last cycle so you don't have to reprogram each time.
When the dishwasher is loaded and door latch is in the locked position, the control panel lights
will be on anti display the last settings you selected.
If you don't want to change any of the settings, simply touch the START/RESET pad to begin the
cycle.
Also, if a power failure occurs, NORMAL and HEATED DRY will automatically be programmed.
Make any new selections and touch the START/RESET pad to begin the cycle.