Craftsman 113.226640 Owner's Manual page 28

' FR
When WIDTH O Ip" is 2in. to 6 in. wide USETH E
PUSH STICK to feed the work.
When WIDTH OF RIP is NARROWER than 2 in., the
push stick CANNOT be used because the guard will
interfere . . . USE the AUXILIARY FENCE/WORK
SUPPORT and PUSH BLOCK.
Attach Aux tiary Fence/Work Support to rip fence
" _ _ S
w thtwo C clamp
Feed the workpiece by hand along the AUXILIARY
FENCE until the end is approx. 1 in. past the front
edge of the table. Continue to feed using the PUSH
BLOCK.
Hold the workpiece in position and install the PUSH
BLOCK by sliding it on top of the AUXILIARY
FENCE/WORK SUPPORT (Th s May Ra se Guard).
28