Craftsman 113.226640 Owner's Manual page 15

1t. Stidethe bars so that screws are r_theMIDD_E
,of the " _ - _o_ted holes
t2. Positio_ r_p fence over miler gauge groove
hoiding up the _ear end while engaging front
end with bar , • _ower fer_ce on_o tab!e
NOTE: It may be necessary to toosen fence
knob to at_ow _ence to be ir_staIled on rip raft
,J
"--::: i[
13, Move FRON"f ba_ upwards unfi! fer_ce is
approxmate!y 1,32 i_. above tab!e . , tighten
screw at left end of bar.
NOTE: Fold a piece of newsp_:_per making 8
thicknesses and p_ace betwee_ rip fence and
tab{e to act as a spacer. This wiit hold the fence
off of the table approx. IJ32 in.
!4. Adjust rear bar so that the fence is
approximately 1/32 ir_, above tabte . . . tighten
sc_ew at end of bar.
15, Replace screws in rear of table extension __. be
sure top surface of exter_sion is PARALLEL to
top surface of rea_ guide bar
8 THICKNESSES
OF PAPER
\
8 THICKNESSES
OF PAPER
16, Move fence to RIGHT edge of _ab_e . ,, make
sure it is approximately t/32 ino above table at
front and rear and tighten screws.
!
_5