Craftsman 152.219070 Instruction Manual page 16

ON-OFF SWITCH
The switch is Uocatedon the side of the motor, To turn
the machine on flip the switch up to the "ON" position,
To turn the machine off, move the switch down to the
"OFF" position,
Figure 21
A_
@
When the tooUis not in use, the switch shouUd be Uocked
in the "OFF" position to prevent unauthorized use, This
can be done by grasping the switch toggUe (A) and
pulling it out of the switch, With the switch toggUe
removed, the switch wHU not operate, ShouUd the toggUe
be removed while the machine is running, the switch
can be turned off once, but cannot be restarted without
inserting the switch toggUe, See Figure 21,
RAISUNG AND LOWERUNG THE HEAD
Figure 22
B
DEPTH STOP ROD
Figure 23
A
The depth stop rod is provided to Hmit the depth of the
chisel, See Figure 23,
1,
2,
To adjust the depth stop rod (A), loosen set screw
(B) using provided 4mm T handle allen wrench,
Lower head until the chisel(C) is at the desired
depth,
3, Lower depth stop rod until it contacts the base (D),
4, Tighten set screw,
The head is raised and lowered by using the lever, For
maximum leverage during the mortising operation, the
lever can be repositioned by pulling out the hub (A) of
the lever assembly and repositioning hub on the pinion
shaft (B), See figure 22,
16